Parkside PHET 15 A1 - Manual (Page 30)

30 GB
Introduction Introduction / General power tool safety warnings
Electric nailer / stapler PHET 15 A1
Introduction
We congratulate you on the purchase of your new
device. You have chosen a high quality product. The
instructions for use are part of the product. They
contain important information concerning safety,
use and disposal. Before using the product, please
familiarise yourself with all of the safety information
and instructions for use. Only use the unit as de-
scribed and for the specified applications. If you
pass the product on to anyone else, please ensure
that you also pass on all the documentation with it.
Intended use
The staple gun is for private use designed to staple
paper, insulating material, leather, fabric (manmade
and natural fibres) and similar material to softwood
or faux wood. Only use in dry areas. Any other uses,
and / or modifications to the appliance, are deemed
to be improper usage and may result in serious phy-
sical injury. The manufacturer is not liable for damage
caused by improper use. This appliance is not in-
tended for commercial applications.
Features
1 Start lockout
2 Trigger
3 Magazine
3a Unlocking device
4 Magazine well
5 Fill level indicator
Scope of delivery
1 Electric nailer / stapler PHET 15 A1
400 Staples 10 mm
100 Nails 14 mm
1 Operating instructions
Technical Data
Model: PHET 15 A1
Rated voltage: 230–240 V∼ 50 Hz
Rated input power: 45 W
Protection class: II /
Fine staples:
Type 53
6–14 mm
Width of staples: 11.4 mm externally
Staple lengths: 6–14 mm
Nails:
Type 47
max. 15 mm
Nail lengths: max. 15 mm
Noise and vibration data:
Measured values for noise are determined in accord-
ance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level:
73.82 dB(A)
Sound power level: 84.82 dB(A)
Uncertainty K: 3 dB
Wear hearing protection!
Vibration total values determined according to
EN 60745:
Vibration emission value a
h
= 4.678 m / s 2 ,
Uncertainty K = 1.5 m / s 2 .
The vibration level specified in
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibra-
tion emission value specified can also serve as a
preliminary assessment of the exposure.
The vibration level will change according to the ap-
plication of the electrical tool an in some cases may
exceed the value specified in these instructions. Re-
gularly using the electric tool in such a way may make
it easy to underestimate the vibration.