Parkside PMFW 280 A2 - Manual (Page 11)

11 GB/IE
Assembly / Bringing into use / Maintenance and cleaning Assembly
Material:
Wood, metal
Use:
· Cutting and plunge sawing
· Close to the edge sawing, even in difficult to
access areas
Example: Laying parquet and other floor coverings,
including plunge sawing. (see Figs. C, E and F)
Scraping knife Z52 A2 9
Materials: Mortar / concrete residues, tile / carpet
adhesives, paint / silicone residues
Use:
· Removal of material residues, for example tile
adhesive when replacing damaged tiles
(see Fig. I)
Q Changing the attached tool
NoTE: If you would like to use the vacuum dust
extraction device, you must connect it before attach-
ing or changing the attachment (see section on
“Connecting a vacuum dust extraction device”).
DANGER oF INJURY! Pull
the mains plug out of the mains socket
before you carry out any task on the
electrical power tool.
Remove any tool already inserted. To do this,
release the clamping screw
10 using the Allen
key 11 and take off the tool.
Place the tool (e.g. plunge saw blade 6 ) on
the tool mount.
NoTE: You can place the tool in any of the
possible positions on the tool mount.
Fasten the tool in place with the clamping
screw
10 and clamping plate 4 . Tighten the
clamping screw 10 using the Allen key 11 .
Check that the tool is firmly seated.
Incorrectly or insecurely attached tools could
become lose during use and injure you.
Q Place a sanding sheet
on the backing plate
Offer up the sanding sheet 12 to fit flushly on
one side of the backing plate 7 , then apply
the sanding sheet to the backing plate.
Q Bringing into use
Q Switching on / off
Slide the ON / OFF switch 1 forwards to
switch on the device.
Slide the ON / OFF switch 1 backwards to
switch off the device.
Q Selecting the oscillation speed
Preselect the required oscillation speed using
the oscillation speed setting wheel
2 .
NoTE: The required oscillation speed depends on
the material and the working conditions and can
be determined by means of a practical test.
Q
Maintenance and cleaning
DANGER oF INJURY! Pull
the mains plug out of the mains socket
before you carry out any task on the
electrical power tool.
Do not use sharp objects for cleaning the device.
Do not allow any liquids to enter the device.
Otherwise the device could be damaged.
Clean the device frequently; for best results, do
this immediately after you have finished using it.
Use a dry cloth to clean the housing – under
no circumstances use petrol, solvents or clean-
ing agents that attack plastic.
A vacuum cleaner is required to thoroughly
clean the device.