Parkside PMFW 280 A2 - Manual (Page 37)

37 GB
Introduction / General safety advice for electrical power tools Introduction
Q Included items
1 Multi-Purpose Tool PMFW 280 A2
1 Plunge saw blade (20 mm) Z20 A2
1 Plunge saw blade (32 mm) Z32 A2
1 Clamping screw and clamping plate (prefitted)
1 Backing plate
1 Segment saw blade Z85 A2
1 Scraping knife Z52 A2
18 Sanding sheets
1 Dust extraction system
1 Allen key
1 Operating instructions
Q Technical data
Rated power consumption: 280 W
Rated voltage:
230 V∼ 50 Hz
No-load rotational speed: n
0
15000–21000 min -1
Protection class: II /
Noise and vibration data:
Measured values for noise are determined in ac-
cordance with EN 60745. The A-weighted noise
level of the electrical power tool are typically:
Sound pressure level:
85.1 dB(A)
Sound power level: 96.1 dB(A)
Uncertainty K: 3 dB
Wear ear protection!
The total vibration (vector sum of three directions) is
calculated in accordance with EN 60745:
Sanding:
Vibration emission value a
h
= 2.930 m / s 2 ,
Uncertainty K = 1.5 m / s 2
The vibration level specified in
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibra-
tion emission value specified can also serve as a
preliminary assessment of the exposure.
The vibration level will change according to the ap-
plication of the electrical tool an in some cases may
exceed the value specified in these instructions. Re-
gularly using the electric tool in such a way may
make it easy to underestimate the vibration.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
General safety advice for
electrical power tools
Read all the safety advice
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
The term “electrical tool” used in the safety advice
refers to electrical tools powered by mains electrici-
ty (by means of a mains lead) and electrical tools
powered by rechargeable batteries (without a
mains lead).
1. Workplace safety
a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
b) Do not work with the device
in potentially explosive envi-
ronments in which there are
inflammable liquids, gases or dusts.
Electrical power tools create sparks, which can
ignite dusts or fumes.
c) Keep children and other
people away while you are
operating the electrical tool.
Distractions can cause you to lose control of
the device.