Parkside PSE 2800 A1 - Manual (Page 13)

8.6 Preparing the equipment for long-term
storage
Warning: Do not empty the petrol tank in
enclosed areas, near fire or when smoking.
Petrol fumes can cause explosions and fire.
Empty the petrol tank using a petrol suction
pump.
Start the engine and run it until the tank and
fuel line are completely empty and the
engine stalls.
Change the oil after each season. To do so,
remove the used engine oil when the engine
is warm and refill new oil.
Remove the spark plug (Fig. 14/Item D).
Use an oil can to fill the cylinder with
approx. 20 ml of oil. Slowly pull back the
starter cord, which will bathe the cylinder
wall with oil. Screw the spark plug back in.
Be sure to clean the entire equipment to
protect the paint.
Store the equipment in a well-ventilated
place or location.
8.7 Preparing the equipment for transport
Empty the petrol tank using a petrol suction
pump.
Always let the engine run until it has used
up the remainder of petrol in the tank.
Empty the engine oil from the warm engine.
Remove the spark plug boot (Fig. 13) from
the spark plug.
Secure the equipment, e.g. with straps,
against shifting.
8.8 Ordering replacement parts
Please provide the following information on all
orders for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
For our latest prices and information please go
to www.isc-gmbh.info
9. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused
or recycled. The equipment and its accessories
are made of various types of material, such as
metal and plastic. Defective components must
be disposed of as special waste. Ask your
dealer or your local council.
For EU countries only
Never place any electric power
tools in your household refuse.
To comply with European Directive 2002/96/EC
concerning old electric and electronic
equipment and its implementation in national
laws, old electric power tools have to be
separated from other waste and disposed of in
an environment-friendly fashion, e.g. by taking
to a recycling depot.
Recycling alternative to the return request:
Instead of returning the equipment to the
manufacturer, the owner of the electrical
equipment is obliged to ensure that the
equipment is properly disposed of if he
abandons ownership. The old equipment can
be returned to a suitable collection point, that
will dispose of the equipment in accordance
with the national recycling and waste disposal
regulations. This does not apply to any
accessories or aids without electrical
components supplied with the old equipment .
13
GB/IE/
CY
Anleitung_4152414_GB_IE_CY:_ 26.10.2011 16:31 Uhr Seite 13