Parkside PRESSURE WASHER BRUSH ATTACHMENT - Manual (Page 10)

10
Intended purpose
The device is designed as an accessory for
the designated pressure washer, for power-
ful wet cleaning. For cleaning smooth sur-
faces such as wall tiles, floor tiles, paving
tiles, stairs or rooms with a floor drain. The
device is strictly not suitable for sensitive
surfaces.
The operator or user is responsible for acci-
dents or damage to other persons or their
property.
The manufacturer is not liable for damage
which is caused through inappropriate use
or incorrect operation. This equipment is not
suitable for commercial use. Commercial
use will invalidate the guarantee.
1 High pressure connection
on the gun side
2 Cap nut
3 Top extension pipe
4 Bottom extension pipe
5 Brush
6 Pull-out lip
Also observe the safety instruction
for your pressure washer.
Pressure washers can be dan-
gerous if used incorrectly. Do
not direct the jet at people, ani-
mals, live electrical equipment or the
equipment itself.
Technical specifications
Use the product only as described and for
the applications specified:
Pressure Washer Brush
Attachement
Rated pressure max. ....110 bar / 11 MPa
Max. pressure .............160 bar / 16 MPa
Max. pumping rate, water........... 450 l/h
Initial Operation
Screw the brush (5) onto the bottom exten-
sion pipe (4). Screw the bottom extension
pipe (4) onto the top extension pipe (3).
Plug in and twist to connect the pressure sc-
rubber to the spray gun of your PHD 150
B2 / PHD 150 A1/ PHD100 B2 /PHD
100 A1 pressure washer via the high pres-
sure connection on the gun side (1). Screw
the cap nut (2) against the spray gun for a
firm grip.
On all surfaces, test the brush (5)
initially on a location that is not
visible, in order to ensure compati-
bility.
Removal of the pressure scrubber is in the
reverse order. Start by loosening the cap
nut (2). Then push and turn the pressure sc-
rubber in the opposite direction to separate
the pressure scrubber from the spray gun.
• Store the equipment in a frost-proof
room.
Guarantee
Dear Customer,
This equipment is provided with a 3-year
guarantee from the date of purchase.
In case of defects, you have statutory rights
against the seller of the product. These
statutory rights are not restricted by our
guarantee presented below.
GB MT