Operating the water supply, After initial use, Cleaning and care – Parkside PDWS 8 A1 User Manual

Page 21: Information about warranty and service processing

General safety instructions

for compressed air

water jets

Never point the device at yourself, other per-

sons or animals. The water leaves the device at
high pressure and speed. This could present a
major hazard.

Preparations for use

Connecting garden and

compressed air hoses

Wear your protective clothing and put on your

safety goggles! Otherwise there is a risk of injury.

Connect your garden hose to the water con-

nection

of the device.

Note: At this point, the device is equipped
with a common click-plug-in system.

If you cannot simply press the hose onto the

connection, please check the compatibility of
the connections.

Never attempt to join the two connections using

excessive force. You will be certain to cause
damage.

Use a ¼“ plug-in coupling to connect the com-

pressed air hose to the compressed air supply

Ensure at all times that the compressed air hose

does not handicap you in your work.

Operating the water supply

Open the main water supply.
Briefly activate the extractor

on the device.

The water leaves the device at high speed.

Only tighten the extractor partially

to regu-

late the air flow and the water quantity leaving
the device.

Vary the water jet by turning the nozzle to the

right or to the left (see fig. B).

Note: You can change the pressure of your
compressor as you wish to adapt it to the cur-
rent requirements.

However, note that the force of the water jet

will be immense if you increase the pressure of
the compressor considerably.

Ensure that you cause no damage by directly

the jet at unstable material.

Never point the device at yourself, other per-

sons or animals.

After initial use

Once the task has been finished the device must be
disconnect from the compressed air supply

Briefly activate the extractor

on the device

to release any compressed air remaining in the
device.

Now pull back the safety mechanism of the con-

nection coupling on your compressed air hose.

Now release the hose.

Be careful when putting down

the device. Always put down the device Always
put down the device so it does not come into
contact with the extractor

. This could poten-

tially result in accidental activation of the device,
which again could result in hazards.

Cleaning and Care

loosen the compressed air connection.
Clean the device with a lightly moistened cloth.
Do not use corrosive or aggressive cleaning

agents.

Information about warranty

and service processing

Creative Marketing
Consulting GmbH warranty

Dear customer, the warranty for this device is 3 years
from the date of purchase. In the event of product
defects you have legal rights against the retailer of
this product. Your statutory rights are not limited in
any way by our warranty detailed below.

… / … / … / Cleaning and Care / Information about warranty and service processing

General safety instructions for air tools

74767_par_Druckluft Wasserstrahler PDWS 8 A1_Content_LB5 (ohne IT).indd 25

16.05.12 15:54