Parkside PSBM 500 A1 - Manual (Page 7)

7 GB
Introduction Introduction / General safety advice for electrical power tools
Q
Included items
1 Impact drill PSBM 500 A1
1 Auxiliary handle
1 Depth stop
1 Operating instructions
Q
Technical data
Nom. voltage: 230 - 240 V~ 50 Hz
Rated power: 500 W
No-load rotational
speed:
max. 3000 min -1
Impact rate: max. 48000 min -1
Chuck capacity: max. 13 mm
Drilling in steel: max. ø 10 mm
Drilling in wood: max. ø 20 mm
Drilling in concrete: max. ø 13 mm
Protection class: II /
Noise and vibration data:
Measured values for noise are determined in accor-
dance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level: 95.2 dB(A)
Sound power level: 106.2 dB(A)
Uncertainty K:
3 dB
Wear ear protection!
Impact drilling in concrete:
Vibration emission value
a
h, ID
= 12.137 m / s 2
Uncertainty
K = 1.5 m / s
2
Drilling in metal:
Vibration emission value
a
h, D
= 5.237 m / s 2
Uncertainty
K = 1.5 m / s
2
The vibration level specified in
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibration
emission value specified can also serve as a prelim-
inary assessment of the exposure. The vibration level
will change according to the application of the
electrical tool an in some cases may exceed the
value specified in these instructions. Regularly using
the electric tool in such a way may make it easy to
underestimate the vibration.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particu-
lar period of working, you should also take into
account the intervening periods of time when the
device is switched off or is running but is not actu-
ally in use. This can result in a much lower vibration
load over the whole of the period of working.
General safety advice for
electrical power tools
Read all the safety advice
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
The term “electrical tool” used in the safety advice
refers to electrical tools powered by mains electricity
(by means of a mains lead) and electrical tools
powered by rechargeable batteries (without a
mains lead).
1. Workplace safety
a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
b) Do not work with the device
in potentially explosive envi-
ronments in which there are