Parkside Pipe Cleaning Set - Manual (Page 14)

14
GB MT
Intended purpose
The pipe cleaning set clears blockages
from pipes, down pipes, drains and toilets.
The equipment is intended for use with
the Parkside PHD 100 A1, PHD 150
and PHD 150 A1 pressure washers. The
equipment is suitable for other pressure
washers if the adapter is used.
The equipment is suitable for the following
pipes:
- Curve C no more than 90°;
- Diameter D at least 40 mm;
- Radius R at least 70 mm.
min
D = 40mm
min
R = 70mm
K = 90°
max
The equipment is not intended for commer-
cial use.
The operator or user is responsible for ac-
cidents or damages to other people or their
property.
The manufacturer is not liable for damages
caused by use other than for the intended
purpose or improper operation.
Before initial start-up, please
read through these operating
instructions carefully prior to
using the machine. Keep the
instructions safe and pass
them on to any subsequent
user so that the information
is always available.
Safety information
Please also observe the safety
instructions for your pressure
washer.
To avoid accidents and injuries:
Pressure washers can be
dangerous if used incorrectly.
Do not direct the jet at people,
animals, live electrical equip-
ment or the equipment itself.
• The device must not be used by people
(including children) with limited physical,
sensory or mental faculties or who lack
the necessary experience and/or know-
ledge - other than they are supervised
by a person responsible for safety or
are being instructed to operate the ap-
pliance by such a person.
• Children must be supervised in order
to ensure that they do not play with the
equipment.
• Operation of the equipment is not per-
mitted for people under the age of 16.
• Do not leave equipment unattended in
the workplace.
• Switch on the pressure washer only
when the pipe cleaning hose is at least
up to the red marking in the pipe to be
cleaned.
• During high pressure operation, do not
pull the inserted hose completely out
of the pipe to be cleaned. The high-
pressure jet could cause injury.
• The maximum washing temperature
must not exceed 60°C. The hose could
be damaged.