Parkside PWP 90 A1 - Manual (Page 36)

34 GB/MT
priate for the demands on and condition of your
paintwork. Heavily oxidised paintwork will require
the use of a special cleaner. For this use a combined
product (cleaner + wax).
1. Place the car polisher on the surface to be pol-
ished.
note: To avoid the splattering of wax or polish,
do not switch the appliance on yet. Dab the
appliance a few times at various points on the
area to be buffed. In this way you can ensure
that excess wax / polish is once more distributed
evenly over the terrycloth bonnet and the area
to be buffed.
2. Take both appliance grips 1 firmly in your
hands and switch the appliance on by pressing
the oN / oFF switch
3 (see also Fig. B).
3. Guide the waxer/polisher evenly over the
paintwork (see Fig. C).
note: Do not press on the waxer /polisher!
The self-weight of the car polisher alone
applies sufficient pressure for the waxing / pol-
ishing process.
4. Switch the appliance off before you remove it
from the area being buffed. To do this, release
the oN / oFF switch
3 .
j Any difficult to reach corners or recesses may
have to be completed later by hand. Take the
terry bonnet
5 off the car polisher and use
the bonnet for the corners and recesses.
Q Polishing or removing wax with
the synthetic polishing bonnet
note: The wax / polish must be allowed to dry on
sufficiently to produce the best polishing performance.
otherwise any polish that is still fluid will be smeared
by the polishing bonnet.
j Use the synthetic polishing bonnet 6 for final
polishing or removing the wax.
j When working, always follow the instructions
for use of the wax / polish.
Q Cleaning and Maintenance
WArnInG!
DAnGEr OF InJUrY! Switch
the device off and pull the plug out of the mains socket
before carrying out any work on the device.
CAUtIOn! Ensure that no fluids can permeate into
the appliance, this could lead to the destruction of
the product.
The appliance is maintenance-free.
j Use a slightly moist cloth to clean the housing,
if necessary with a mild detergent.
j When cleaning the housing, under no circum-
stances should you use strong detergents,
solvents or abrasives.
j Clean the bonnet by washing by hand in
soapy water.
Q Service centre
J WArnInG!
Have your device re­
paired only by qualified specialist
personnel using original manufactur­
er parts only. This will ensure that your de-
vice remains safe to use.
J WArnInG!
If the plug or mains lead
needs to be replaced, always have the
replacement carried out by the manu­
facturer or its service centre. This will en-
sure that your device remains safe to use.
Q
Warranty
the warranty for this appliance is for 3
years from the date of purchase. the ap­
pliance has been manufactured with care
and meticulously examined before deliv­
ery. Please retain your receipt as proof
of purchase. In the event of a warranty
claim, please make contact by telephone
with our Service Department. Only in this
way can a post­free despatch for your
goods be assured.
operation / Cleaning and Maintenance / Service centre / Warranty
58811_par_Poliermaschine_Content_LB5.indd 34 16.11.10 13:07