Parkside PWP 90 A1 - Manual (Page 35)

33 GB/MT
f) Keep cutting tools clean and sharp.
Carefully maintained cutting tools with sharp
cutting edges are less likely to jam and are
easier to control.
g) Use the electrical power tool, accesso­
ries, inserted tools etc. in accordance
with these instructions and advice, and
the stipulations drawn up for this par­
ticular type of device. In doing this, take
into account the working conditions
and the task in hand. The use of electrical
power tools for purposes other than those in-
tended can lead to dangerous situations.
Safety advice for
car polisher
Avoiding the danger of injury, fire and
damage to your health:
J Always pull the plug out of the mains socket
before cleaning or maintaining the device.
J Ensure that the bonnet is well secured to the
buffing plate.
J Do not touch any rotating parts!
Before switching on check to ensure that the
buffing plate is not blocked and can start up
without problem.
J Check to ensure that the bonnet and the buffing
plate are complete and undamaged. Immedi-
ately exchange torn or damaged bonnets /
buffing plates.
J Wait until the polishing disc is flat on the surface
to be polished before switching on the waxer /
polisher.
J Do not use any abrasives; these can destroy
the paint finish.
Q Original ancillaries /
accessories
J Use only the ancillaries and accessories
that are detailed in the operating in­
structions. The use of parts other than those
recommended in the operating instructions, or
other accessories, can put you at risk of injury.
Q
Understood everything?
J When you have become familiar with these
general safety instruction for electrical appli-
ances, and, with the help of the appropriate
operating instructions, know all about the func-
tions and handling of your electrical appliance,
then you can start working with it. You will
work at your safest only with careful attention
to all of the declarations and instructions of the
manufacturer.
Q
Operation
Q Placing the bonnet on the
buffing plate
1. Turn the car polisher over so that the polishing
disc 2 is pointing upwards.
2. Place the bonnet 5 6 over the buffing
plate 2 . Ensure that the bonnet 5 6 is placed
centrally and taughtly onto the buffing plate.
Q
Applying wax / polish
with the terry bonnet
1. Always use high quality products for waxing.
j Follow the working methods given on the
packaging.
2. Apply the wax / polish directly on the working
surface of the terry bonnet 5 .
j Spread the wax / polish so that it forms a thin,
even, complete coating over the terry bonnet
5 .
note: Too much wax does not necessarily
achieve a better finish and you will have to
spent more time later removing the coating.
3. Spread the wax evenly right up to the edge of
the terry bonnet 5 .
Q Switching on the device and
waxing / polishing the paintwork
note: The paintwork to be polished must be care-
fully cleaned and completely dry. If necessary, use
a paintwork cleaner. Use products that are appro-
General safety advice for electrical power tools / operation
58811_par_Poliermaschine_Content_LB5.indd 33 16.11.10 13:07