Parkside PGG 15 A1 - Manual (Page 63)

63 GB/MT
Remove the spring and the plain washer.
Push the plain washer and spring on to a new engraving point 5 .
Then insert this and turn the engraving point holder 6 clockwise
to lock the engraving point in position.
Ensure that the engraving point 5 is properly fixed in position.
Advice on use
You can use the mini-engraver to produce creative, individual engravings.
For example, you can use it to place identifying marks on your valuables.
You can place numbers and letters on metal, glass, plastic, wood and
ceramic. This is done with the help of the supplied engraving stencils
7 ,
see Figs. A and B.
Hold the device at an angle, as you would a pencil.
Your arm should rest on the table.
Using very light pressure, guide the engraving point 5 over the
workpiece. Find the ideal speed of movement by trial and error on
a piece of waste material.
Note: The engraving point 5 supplied with the product is made
from tungsten steel. Therefore it is not suitable for engraving electronic
media such as CDs, DVDs etc. It could damage these materials and
render them illegible.
Cleaning
Before performing any cleaning or maintenance
work, always remove the mains plug from the socket.
Clean all the dirt off the device. Use a dry cloth for cleaning.
Operation / Cleaning
66133_Mini-Graviergerät_content_LB5.indd 63 03.06.11 16:58