Setting the stroke rate, Changing the engraving point, Operation – Parkside PGG 15 A1 User Manual
Page 62
62 GB/MT
Switching on:
Press the ON / OFF switch
1
.
Switching off:
Release the ON / OFF switch
1
.
Setting the stroke rate
The stroke switch
2
is used to set the penetration depth of the engrav-
ing. A low setting is normally adequate for most engraving tasks.
Turn the switch for the number of strokes
2
in the
+ direction to
increase the penetration depth.
Turn the switch for the number of strokes
2
in the
– direction to
decrease the penetration depth.
Note: Take care when increasing the penetration depth that you do
not turn the stroke switch
2
too far in the
+ direction. Otherwise the
switch could screw off the device.
Changing the engraving point
RISK OF INJURY! Switch the device off before
performing any tasks on the device and pull the mains plug out of the
mains socket.
Replace the engraving point
5
as soon as it becomes too worn
and no longer provides the desired engraving performance. Turn
the engraving point holder
6
anticlockwise until the engraving
point
5
is released.
Operation
66133_Mini-Graviergerät_content_LB5.indd 62
03.06.11 16:58