Esoteric AI-10 - Manual (Page 12)

12
power indicator
First of all, turn on the power of the connected
components. 1
If the power indicator is red, press the ON button of the
remote control unit to turn the unit on (see page 11).
It may take several seconds for the unit to start outputting
sounds. Wait until “WAIT ...” disappears from the display.
Select an input by turning the INPUT knob. 3
The current input appears on the left of the display.
Repeatedly turn the knob until the desired input appears on
the display.
COAX, OPT, LINE1, LINE2, LINE3,
LINE4 or PHONO*, i.LINK**
*: PHONO appears only when the LINE/PHONO switch is set to
PHONO.
< “COAX” or “OPT” blinks when the unit cannot perceive the
digital signal. In that case, connect a digital device to the
DIGITAL IN (COAXIAL or OPTICAL) terminal and switch it on.
**: “i.LINK” will be added after a future hardware upgrade
(charged). i.LINK indicator blinks when the unit cannot
perceive the digital signal. In that case, connect a digital
device to the i.LINK(AUDIO) terminal and switch it on.
Play the source, and gradually turn up the volume to
the required level by turning the VOLUME knob. 4
Basic Operation
To turn the unit off (standby)
To prevent sudden noise from the speakers, make sure to turn
the unit off in the following way.
1. Stop the playback of the connected component.
2. Turn the AI-10 off using the POWER button.
< Use the STANDBY button of the remote control unit to turn
the AI-10 standby.
3. Turn the connected components off.
Press the POWER button to turn the AI-10 on. 2
2 4 3