beautypg.com

Starting cold engine – Echo GT-251E User Manual

Page 13

background image

G

RASS

T

RIMMER

O

PERATOR

'

S

M

ANUAL

13

STARTING

COLD

ENGINE

WARNING

DANGER

The attachment will operate immediately when the engine starts and
could result in loss of control and possible serious injury. Keep
movable parts of the attachment off the ground and away from
objects that could become entangled or thrown.

1. Stop Switch

Move stop switch button (A) away from the STOP position.

2. Choke

Move choke (B) to “Cold Start” (

) Position.

3. Purge Bulb

Pump purge bulb (C) until fuel is visible and flows freely in the clear
fuel tank return line. Pump bulb an additional 4 or 5 times.

4. Recoil Starter

Lay the unit on a flat area and keep movable attachment parts clear
of all obstacles. Firmly grasp right hand grip with left hand and fully
depress throttle trigger to wide open position. Rapidly pull recoil
starter handle/rope (D) until engine fires (or maximum five [5] pulls).

5. Choke

After engine fires or five (5) pulls, move choke lever (B) back to

“Run” (

) position. Hold throttle trigger fully depressed and pull

recoil starter handle/rope until engine starts and runs. Allow engine
to run at partial throttle for approximately 10 seconds. Release
throttle trigger and allow unit to warm up at idle for several minutes.

NOTE
If engine does not start with choke in “Run” position after 5 pulls,
repeat instructions.

6. Throttle

After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.

A

B

C

B

D