Extron electronic P/N 68-412-02 - Manual (Page 6)

Extron • System 4 xi Switcher Series • User’s Manual • P/N 68-412-02 Rev. A
Hughes Installation Configuration and Connections
Page 5
SW1
ON
SW2
SW4
SW3 SW5
J15
3 4 1 2
Connecting System 4
xi
to Hughes-JVC DILA G1000/G10 Projectors
If the System 4 xi is already configured for a Hughes-JVC DILA projector, go to
step 4. If it is not set up correctly, it will be necessary to change switch settings
on the System 4
xi
’s Main Controller Board. Begin at Step 1 to verify the correct
configuration.
1. Use the Front Panel to display the Information Menu to verify that the System 4 xi
is already set up for the Hughes-JVC DILA projector. Apply power to the
System 4
xi
and do the following:
a. Press to display the M ENU S ELECT on the LCD screen.
b. Press or to step to Menu 8.
c. Press to select this menu.
d. Press or to display the configuration. The example to the left is general,
your display will show the System 4
xi
model name, the software version and
the following information:
PRJ = HUGHES
PRJ BAUD = 19200
UNIT No.= 000
HST BAUD = 9600 (value depends upon setup Menu 3)
2. Go to the procedure on page 2-3 of the System 4 xi User’s Manual to remove the
System 4
xi
cover. Then go to page 2-4 and refer to the configuration below to
set up the Main Controller board. Continue with Step 3 (below) when the
configuration is correct.
Config Projector SW1: 1-2-3-4 SW2 SW3 SW4 SW5 SW6 Prj Cable Comm
as Adapter
Hughes/JVC DILA off-on-off-on 0 0 8 F 0 J15 26-467-01
3. Double-check your work and be sure the System 4
xi
cover is on securely.
4. Install the System 4 xi in its place of operation (i.e. rack), but do not connect the
power cable.
__________ Changes in some switch configurations are not detected until the power is
removed at the AC cord, and then restored.
Refer to the following connection diagrams for your Hughes projector and
continue the installation. Use the UNV ADP “A” (26-467-01) provided by Extron.
}
(Note: Information depends on
System 4 setup.)
(See note.)
(See note.)
(See note.)
(See note.)
[System 4 model and software
version displayed here]