Extron electronic P/N 68-412-02 - Manual (Page 2)

Extron • System 4 xi Switcher Series • User’s Manual • P/N 68-412-02 Rev. A
Hughes Installation Configuration and Connections
(Note: Information depends on
System 4 setup.)
(See note.)
(See note.)
(See note.)
(See note.)
[System 4 model and software
version displayed here]
Page 1
}
Connecting System 4
xi
to Hughes/JVC Projectors
If the System 4 xi is already configured for a Hughes/JVC projector, go to step 4.
If it is not set up correctly, it will be necessary to change switch settings on the
System 4
xi ’s Main Controller Board. Begin at Step 1 to verify the correct
configuration.
1. Use the Front Panel to display the Information Menu to verify that the System 4 xi
is already set up for the Hughes/JVC projector. Apply power to the System 4 xi
and do the following:
a. Press to display the M ENU S ELECT on the LCD screen.
b. Press or to step to Menu 8.
c. Press to select this menu.
d. Press or to display the configuration. The example to the left is general,
yours will show the System 4 xi model name, the software version and the
following information:
PRJ = HUGHES
PRJ BAUD = 19200
UNIT No.= 000
HST BAUD = 9600 (value depends upon setup Menu 3)
2. Go to the procedure on page 2-3 to remove the System 4 xi cover and then go to
page 2-4 to set up the Main Controller board. Return to Step 3 (below) when the
configuration is correct.
Config Projector SW1: 1-2-3-4 SW2 SW3 SW4 SW5 SW6 Prj Cable Comm
as Adapter
✔ Hughes-JVC off-on-off-on 0 0 5 6 0 J15 26-467-01
3. Double-check your work and be sure the System 4 xi cover is on securely.
4. Install the System 4
xi
in its place of operation (i.e. rack), but do not connect the
power cable.
__________ Changes in some switch configurations are not detected until the power is
removed at the AC cord, and then restored.
Follow the correct cable connection diagram for your Hughes projector and
continue the installation.
5. The UNV ADP, “A” (26-467-01) has two 9-pin connectors, one male and one
female. Plug the 9-pin female connector onto the 9-pin male marked “Control
Out” (Port B) on the Hughes projector back panel.
SW1
ON
SW2
SW4
SW3 SW5
J15
3 4 1 2