LinPlug Organ 3 - Manual (Page 23)

Spl 1: Upper and Lower Manual are “split” at the split points which are
defined in the “Settings” Menu. At the split point and above you hear the
Upper Manual. Under the split point you hear the Lower Manual. Organ 3
receives on the MIDI-channels of the Upper and Lower Manuals
simultaneously. The Pedal receives on the third MIDI-channel and is not
affected by the split points.
Spl 2: complete-split. Upper Manual, Lower Manual and Pedal are “split”
at the split points that are set in the “Settings” Menu. Organ 3 receives its
MIDI-information on all three MIDI-channels simultaneously.
ECS
The ECS (Easy Controller Setup) buttons to the right of the Play Mode
button make it simple to control Organ 3 from an external MIDI controller
(either hardware or software).
All you have to do is switch on the small button to the right of the ECS
button, select a Organ 3 parameter with the mouse and then send some
MIDI messages from your MIDI source. That's all there is to it! From now
on you can change this parameter with that controller. In addition to this,
more than one controller can be defined to change a particular paramet-
er. In fact, you can define up to 128 parameter-controller-combinations.
This does not depend on the type of controller you have nor the particu-
lar MIDI Control Change messages it sends. Don't forget to switch off the
small ECS button after you have finished using it! As long as ECS learn
is activated the small button will be shining.
Left-clicking the ECS-button opens up a menu where you can select one
of the following ECS-functions:
LinPlug Organ 3 User Guide Page 23