LinPlug MorphoX - Manual (Page 45)

Osc 1 or 2 Spread Volume If Spread is used in the respective
oscillator, one can hereby control the volume of
the additional voices within the range null (no
additional sound) up to the full volume.
Osc 2 Ringmod Controls the output of oscillator 2 in the same way
as the Ringmod parameter below osc 2 in the
mixer, thus allows to dynamically change the mix of
oscillator 2 and the ring modulators output.
Osc 2 FM Amount Controls the amount of frequency modulation of
oscillator two by oscillator one.
Filter Cutoff Cutoff frequency of the Filter, often used with an
LFO to create filter sweeps or with Velocity to
simulate an acoustic instrument's response to note
attack.
Filter Cutoff FM The intensity of the FM modulation of the filters
cutoff frequency.
Filter Resonance Resonance of the Filter, sometimes a rather subtle
effect, sometimes drastic.
Filter Env-Depth Controls with how much the filter envelope affects
the filter cutoff frequency.
Filter LP Volume The volume of the low pass output of the filter.
Filter BP Volume The volume of the band pass output of the filter.
Filter HP Volume The volume of the high pass output of the filter.
Main Amplitude Used to control the overall volume of the patch.
Main Pitch Used to control the overall pitch of this patch.
Main Noise Volume Allows modulation of the noise amount in the
oscillator mixer.
Main Osc Stereo When oscillator one or oscillator two runs in
Spread mode, the different voices are usually
centered.
MorphoX user manual 1.1.0 page 45