beautypg.com

Change oil filter (ec21ka, Check condition of belt (self-propelled, Units only) – Exmark Commercial 21 850 User Manual

Page 29: Fuel filter, Check spark plugs, Maintenance

background image

Maintenance

Change Oil Filter
(EC21KA, EC21KABBC,
EC21KAX, EC21KAY,
EC21KABBCX,
EC21KABBCY, EC21KACA,
and EC21KABBCCA)

Service Interval: Every 100 hours

1. Run the engine to warm the oil.

2. Stop the engine and wait for all moving parts to

stop.

3. Disconnect the wire from the spark plug.

4. Drain the engine oil.

5. Place a rag under the oil filter to catch any oil that

may leak out as you remove the filter.

6. Remove the oil filter.

7. Use your finger to coat the gasket on the new

filter with clean engine oil (see Figure 30).

Figure 30

1.

Gasket

8. Install the new filter and hand tighten it 2/3 turn

only.

9. Fill the crankcase to the Full line on the dipstick

with fresh oil.

10. Connect the wire to the spark plug.

11. Run the engine for about 3 minutes.

12. Stop the engine, wait for all moving parts to stop,

and check for oil leakage around the filter.

13. Add oil to compensate for the oil in the oil filter.

14. Recycle the used oil filter according to local codes.

Check Condition Of Belt
(Self-Propelled Units Only)

Service Interval: Every 40 hours

1. Stop engine, wait for all moving parts to stop.

2. Remove the belt cover to the lawn mower housing.

3. Check the belt for cracks, frayed edges, burn

marks or any other damage.

4. Replace the damaged belt.

Check Spark Plugs

Service Interval: Every 100 hours

1. Stop the engine and wait for all moving parts to

stop.

2. Disconnect the wire from the spark plug

(Figure 10 and Figure 11).

3. Clean around the spark plug.

4. Remove the spark plug from the cylinder head.

Note: Replace a cracked, fouled, or dirty spark
plug. Do Not clean the electrodes because grit
entering the cylinder can damage the engine.

5. Set the gap on the plug to 0.030 inch (0.76 mm)

(Figure 31).

Figure 31

1.

Side electrode

3.

Air gap—0.030 inch
(0.76 mm)

2.

Center electrode
insulator

6. Install the spark plug and the gasket seal.

7. Torque the plug to 17 ft-lb (23 N-m).

8. Connect the wire to the spark plug.

Emptying the Fuel Tank and
Cleaning the Fuel Filter

Service Interval: Every 100 hours

29

This manual is related to the following products: