Lanner LEC-7220 - Manual (Page 16)

16
Hardware Setup
Chapter 4
Embedded and Industrial Computing
Chapter 4:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first.
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from the
server. The front panel Power On/Standby button
does not completely shut off system power.
Portions of the power supply and some internal
circuitry remain active until AC power is removed.
Unpower the LEC-7220 and remove the power cord. 1.
Unscrew the 4 rubber feet from the outside of the 2.
bottom cover.
Open the cover.
3.
Installing the System Memory
The motherboard supports DDR3 memory. It comes with
one Double Data Rate (DDR3) Small Outline Dual Inline
Memory Modules (SO-DIMM) sockets.
Align the SO-DIMM connector key with the SO-DIMM 1.
socket key.
Install the SO-DIMM.
2.
Note:
The motherboards can support up to 4 GB 1.
memory capacity in maximum.
Installing the Hard Disk
The system can accommodate one Serial-ATA disk. Follow
these steps to install a hard disk into the LEC-7220:
Place hard disk on the inside of the bottom cover and 1.
align the holes of the hard disk with the mounting
holes on the cover.
Secure the hard disk with 4 mounting screws through
2.
the bottom cover from the outside.
Connect the Serial-ATA cable to the hard disk.
3.
Plug the Serial-ATA power and data cables to the Serial- 4.
ATA power and data connectors on the main board.
1