Lanner LEC-3012 - Manual (Page 14)

14
Board Layout
Chapter 3
Embedded and Industrial Computing
Connectors and Jumpers List
The tables below list the function of each of the board
jumpers and connectors by labels shown in the above
section. The next section in this chapter gives pin
definitions and instructions on setting jumpers.
Table 3.1 Connector List for LEB-3012
Labels Function Pin Definition Reference
Page
CN1 DC-in Connector P15
CN2 CF Card Slot P15
CN3 Dual USB Port P15
J2 SMBus (System Management Bus) Communi-
cation Pin Header
Reserved for Factory Use
J3 SATA Connector P15
J4 SATA Power Connector P15
J5 SPI-ROM Header Reserved for Factory Use
J6 Board to Board Connector P16
JP1 Clear CMOS Pin Header P16
RJ1/RJ2 LAN1/LAN2 P15
USB1 Additional USB Pin Header P15
VGA1 VGA Port P15
Table 3.2 Connector List for LEK-AU4
Labels Function Pin Definition Reference
Page
CN1 COM Port 1~4 P17
J1 SATA Connector P17
J2 SATA Power Connector P17
LAN3/LAN4 LAN3/LAN4 P18
Table 3.2 Connector List for LEK-AU6
Labels Function Pin Definition Reference
Page
CN1 COM Port 1~4 P17
CN2 COM Port 5~6 P18
J1 SATA Connector P17
J2 SATA Power Connector P17
LAN3/LAN4 LAN3/LAN4 P18
Table 3.2 Connector List for LEK-AU8
Labels Function Pin Definition Reference
Page
CN1 COM Port 1~4 P17
CN2 COM Port 5~8 P18
J1 SATA Connector P17
J2 SATA Power Connector P17