Onfiguring the, Bios, On the – Lanner AV-ICE01 User Manual
Page 9: Ystem, 1 configuring the bios on the system
Software User Manual Version 1.0.1
6
Chapter 2. Installing the OS and Preparing for
the Software Installation
2.1 Configuring the BIOS on the System
The BIOS configuration needs to be updated to allow the operating system to be
successfully installed on the development kit.
The following steps must be performed to properly configure the BIOS:
1. Power on the development kit. Watch closely for the prompt to enter BIOS setup.
Press F2 (or other command as instructed by your system’s manual) when
prompted.
2. Update the Boot order so that the DVD-ROM drive is the first boot option. The
option is available under:
Boot > Boot Option Priorities (the menu directory depends on your BIOS)
3. Ensure the SATA mode is set to AHCI
Advanced > SATA Configuration > SATA Mode>AHCI Mode
4. Disable
Intel®
SpeedStep technology (if this option is configurable)
Advanced > Power & Performance > Intel (R) SpeedStep(tm)
Save your changes and exit. Then reboot the system.