Lanner FW-8771 - Manual (Page 13)

8
Hardware Setup
Chapter 2
Network Application Platforms
CPU and the Heat Sink Installation
The FW-8771 sever system is powered by the MB-8771
sever board, which comes with one ZIF type LGA1150 CPU
socket.
Follow the procedures bellow for installing a CPU
Press the load lever and release it from the retention 1.
tab.
Lift the load lever and then the plate.
2.
Remove the CPU socket cap. 3.
Align the CPU key and the notch on the socket. The 4.
CPU should fit perfectly into the socket. Note that the
CPU fits in the socket in only one direction.
Close the plate and push the load lever to lock it back
5.
to the retention tab.
Peel off the sticker on the CPU to expose the thermal
6.
compound.
Put the heat sink on top of the installed CPU, and match
7.
the screws with the screw holes on the board. Fasten
two screws which are opposite to each other at a time
and then the other two. It is easier this way because of
the force of the spring.
Place the heat sink cover on top of the installed heat
8.
sink and screw the three screws to fasten it on the
case.
2 3
1
Note:
The CPU heat sink can only be installed in only 1.
one orientation as shown in the picture.
To protect the CPU socket pins, retain the CPU 2.
cap when the CPU is not installed.
4
5
7
6