Laney LV300 - Manual (Page 15)

In order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with normal Household
waste to landfill sites. It must be taken to an approved recycling centre according to the recommendations of the
WEEE (Waste Electrical and Electronic Equipment) directive applicable in your country.
This product conforms to the requirements of the following European Regulations, Directives & Rules:-
CE Mark (93/68/EEC), Low Voltage (2006/95/EC), EMC (2004/108/EEC),
RoHS (EU2002/95/EC), WEEE (EU2002/96/EC)
Amplifier connection: In order to avoid damage, it is advisable to establish and follow a pattern for
turning on and off your equipment. With all system parts connected, turn on source equipment, tape
decks, cd players, mixers, effects processors etc. BEFORE turning on your guitar amplifier. Many products
have large transient surges at turn on and off which can cause damage to your speakers. By turning on
your guitar amplifier LAST and making sure its Volume controls are set to minimum any transients from
other equipment will not reach your loudspeakers. Wait until all system parts have stabilised; usually a
couple of seconds. Similarly when turning off your system always turn down the Volume controls on your
guitar amplifier and then turn off its power before turning off other equipment.
Cables: never use shielded or microphone cable for any speaker connections as this will not be
substantial enough to handle the amplifier load and could cause damage to your amplifier system.
Caution: These professional loudspeaker systems are capable of generating very high sound pressure
levels. Use care with placement and operation to avoid exposure to excessive levels that can cause
permanent hearing damage. (Refer to guidelines on page 2)
Servicing: The user should not attempt to service these products. Refer all servicing to qualified service
personnel.
GENERAL NOTES
15