Laney LV300 - Manual (Page 13)

13
Switch in to activate the drive1 channel. When active, control the amount of distortion with and the
overall volume with . The centre of the switch will be lit when active.
Sets the level of gain on the drive1 channel. For optimum results the gain control should be used in
conjunction with the volume control . Setting medium levels of gain with high levels of volume will result
in a nice crisp blue’sy lead tone. Setting the gain control to 8-10 will give you a punchy hard rock lead tone.
Obviously the type of guitar you use will have an effect on the overall sound you hear.
Controls the overall level on the drive1 channel. Use in conjunction with .
The VScoop
switch drastically cuts out any mid frequencies present in the drive2 sound giving you a
very modern, aggressive lead tone.
Switch in to activate the drive2 channel. When active, control the amount of distortion with and the
overall volume with . The centre of the switch will be lit when active.
Sets the level of gain on the drive2 channel. For optimum results the gain control should be used in
conjunction with the volume control . Setting low levels of gain with high levels of volume will result in a
nice crisp blue’sy lead tone. Setting the gain control to midway with a medium volume level will give you a
punchy hard rock lead tone and setting the gain to maximum and backing the volume off, gives you a full on
metal lead tone. Obviously the type of guitar you use will have an effect on the overall sound you hear.
Controls the overall level on the drive2 channel. Use in conjunction with .
Controls the amount of bass or bottom end present on the two drive channels.
Controls the amount of mid present on the two drive channels.
Controls the amount of treble present on the two drive channels.
The ‘VTS Tone Shaping’ Radically alters the EQ of the amplifier by cutting some of the lower mid tones and
carefully boosting certain bass and upper mid frequencies. It is a global setting and may be used on any of
the channels giving you lots of different sound possibilities.
Sets the amount of reverb applied to the clean channel
Sets the amount of reverb applied to drive1 and drive2 channels.
Main power switch for the unit. Note: One of the three channel led’s will always be lit when the amplifier is
switched on.
10
11
11
10
14
15
15
14
Always switch off and disconnect power cord when not in use