beautypg.com

Emission control (exhaust & evaporative) – Echo SRM-265 User Manual

Page 6

background image

6

equIpment

WARNING

Use only ECHO approved attachments. Serious injury may result from the use of a non-approved attachment com-

bination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which

have not been tested and approved by ECHO. Read and comply with all safety instructions listed in this manual and

safety manual.

• Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.

• Inspect shield for damage and ensure that the cut-off knife is securely in place. Replace if either is damaged or miss-

ing.

• Check that the cutting attachment is firmly attached and in safe operating condition.

• Check that front loop handle and shoulder strap/ or shoulder/waist harness are adjusted for safe, comfortable opera-

tion. See Assembly Section for proper adjustment.

WARNING

Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all

openings.

ALWAyS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop

before removing obstructions, clearing debris, or servicing unit.

DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.

NEVER reach into any opening while the engine is running. Moving parts may not be visible through openings.

WARNING

Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or leaks are found,

do not use unit, otherwise serious personal injury or property damage may occur. Have unit repaired by an authorized

servicing dealer before using.

PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)

The 300 hour emission durability compliance period is the time span selected by the manufacturer certifying the

engine emissions output meets applicable emissions regulations, provided that approved maintenance procedures are

followed as listed in the Maintenance Section of this manual.

e

mIssIon

c

ontrol

(

eXhaust

&

evaporatIve

)

EPA 2010 and Later

The emission control system for the engine is EM/TWC (Engine Modification and 3-way Catalyst) and for the fuel tank

the Control System is EVAP (Evaporative Emissions) or N (for nylon tank). Evaporative emission may be applicable to

California models only.

An Emission Control Label is located on the engine. (This is an EXAMPLE ONLY, information on label varies by

engine FAMILY).