Lubrication – Echo SRM-265 User Manual
Page 24
24
A
A
lubrIcatIon
Level 1.
Tools Required: 8 & 13mm Open End Wrench, Screwdriver, Clean
Rag, Grease Gun
Parts Required: POWER BLENDX
TM
8 oz. (P/N 91014) or Lithium
Base Grease.
Gear Housing
1. Clean all loose debris from gear box.
2. Remove plug (A) and check level of grease.
3. Add grease if necessary. DO NOT over-fill.
Drive Shaft
(SRM-265 Only)
1. Loosen two (2) screws (B) and remove center locating screw (C).
Pull gear box and shield from drive shaft housing.
2. Pull flexible cable from the drive shaft housing, wipe clean and
re-coat with a thin coating [15 ml (1/2 oz.)] of grease.
3. Slide the flexible cable back in the drive housing. DO NOT get
dirt on the flex cable.
4. Install the gear housing and shield assembly.
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
(SRM-265S Only)
No Lubrication Needed.
B
C
B
D
- GT-225 (32 pages)
- SRM-210 (32 pages)
- SRM-225 (44 pages)
- SRM-225 (24 pages)
- PAS ARTICULATING HEDGE CLIPPER ATTACHMENT PAS-2601 (20 pages)
- 670-200 (20 pages)
- PE-2000 Type 1/1E (30 pages)
- X7502026001 (36 pages)
- SB (56 pages)
- 99944200610 (24 pages)
- PAS RAPID LOADER 99944200610 (16 pages)
- SRM-261SB (16 pages)
- SRM-210SB (32 pages)
- PAS-230 (24 pages)
- PAS-230 (32 pages)
- PAS-230 (24 pages)
- PAS-260 (42 pages)
- PAS-261 (25 pages)
- 2410 - Type 2E (32 pages)
- GT-201 (28 pages)
- POWER PRUNER PPT-2400 (16 pages)
- HC-155 (32 pages)
- HC-155 (36 pages)
- Trimmer (20 pages)
- SRM - 265U (36 pages)
- HC-150 (28 pages)
- HC-235 (32 pages)
- HC-225 (32 pages)
- BLADE CONVERSION KIT 231 (8 pages)
- TC-2100 (28 pages)
- SRM-400 (20 pages)
- SRM - 260S (28 pages)
- 54 (4 pages)
- HCA-2400 (36 pages)
- CULTIVATOR PRO ATTACHMENT 99944200513 (16 pages)
- RM-5000 (68 pages)
- SRM-265T (44 pages)
- SHC-210 (28 pages)
- 2110 (37 pages)
- PE-3100 Type 1/1E (28 pages)
- SRM-265S (42 pages)
- SRM - 230U (32 pages)
- SRM-225I (36 pages)
- 99944200553 (16 pages)
- 99944200553 (24 pages)