Ethernet i/p demonstration unit, Set up and configuration, Using the ethernet demo – Yaskawa SI-EN3 EtherNet/IP User Manual
Page 6: Ethernet demo connections, Si-en3 option, Parameters to adjust, Start, run drive fwd at 60 hz, Touch screen input switches
Page 6 of 8
APPENDIX A
This section contains some helpful screen shots of details referenced above.
Page 12
PP.YAI-NSM-COM.01 | Rev 1.00 | Date: 12/14/2010 | © 2010 Yaskawa Electric America, Inc. All rights reserved.
Ethernet I/P Demonstration Unit
Image Place Holder
Set Up and Configuration
Ethernet Demo Connections
SI-EN3 Option
Parameters To Adjust
»
b1-01 = 3 (Ref Source “Option PCB”)
»
b1-02 = 3 (Run Source “Option PCB”)
»
F7-13 = 0 (IP Add Mode Sel “User Defined”)
Page 13
PP.YAI-NSM-COM.01 | Rev 1.00 | Date: 12/14/2010 | © 2010 Yaskawa Electric America, Inc. All rights reserved.
Ethernet I/P Demonstration Unit
Image Place Holder
Using the Ethernet Demo
Start, Run drive Fwd at 60 Hz
Touch Screen Input Switches
»
Switch 1, External Fault (EF3)
»
Switch 2, Fault Reset
»
Switch 3, Analog Input (A3 on A1000 Demo)
»
Switch 4, Freq Ref from A1000 (d1-03)
»
Switch 5, Jog Ref, 6Hz (d1-17)
»
Switch 6, Base Block