Yaskawa VS-606V7 - Manual (Page 9)

1 Overview
9
1 Overview
The SI-T/V7 Interface Unit is an interface unit that connects to the MECHATROLINK-I or
MECHATROLINK-II high-speed field network for communicating with the host controller.
By installing the SI-T/V7 Unit to a VS-606V7-series Inverter, various applications are enabled;
monitoring of the run/stop status and the operating conditions as well as the changing and the
referencing of the settings for the Inverter constants from the host controller.
The SI-T/V7 Unit can be installed in the following Inverters.
• VS-606V7-series Inverter, software No. 5650.
• VS-606V7-series Inverter, software No. 573X.
Note: 1. “X” indicates the design revision order.
2. The Inverter software will soon be updated from version No. 5650
to No. 573X.
VS-606V7 Inverter with an SI-T/V7 Unit does not conform to CE Marking, although the VS-606V7
Inverter itself conforms to CE Marking.
2 Checking the Product
Check the following items as soon as the product is delivered.
Contact your Yaskawa representative immediately if any failure should be found concerning the
above items.
2.1 Nameplate
The following diagram shows the nameplate on the side of the SI-T/V7 Unit.
* “X” indicates the design revision order.
IMPORTANT
Item Method
Is there any discrepancy between the shipment and
what was ordered? Check the information printed on the Unit. (Refer to 2.1.)
Has the product been damaged in any way? Inspect the entire exterior of the Unit for any damage that
may have occurred during shipping.
Are the contents of the package correct? Check the contents shown in the table below.
SER NO :
YASKAWA ELECTRIC
CORPORATION
LOT NO :
PRG :
CODE NO : 73606-V706X
INTERFACE UNIT SI-T/V7
MASS : 0.5kg
MADE IN
JAPAN MS
Manufacturing No.
Lot No.
Program No.
Code No.*
SI-T/V7 Unit type
Mass