Yaskawa V1000 Option Mechatrolink-II SI-T3/V - Manual (Page 20)

5 Installation Procedure
20 YASKAWA ELECTRIC TOBP C730600 49A V1000 Option MECHATROLINK-II Installation Manual
4.
Reattach the bottom cover.
5.
Connect the MECHATROLINK-II Option to the drive. Properly secure the tabs on
the left and right sides of the MECHATROLINK-II Option to the drive case.
Figure 9
Figure 9 Attach MECHATROLINK-II Option
6.
Connect the ground cable from the drive ground terminal to the MECHATROLINK-II
Option ground. When wiring the MECHATROLINK-II Option, pass the ground cable
through the inside of the drive bottom cover, then pass the ground cable into the
through-hole at the front of the MECHATROLINK-II Option.
Figure 10
Figure 10 Ground Cable Connection
7.
Connect the communications cable to the connector.
Tabs should line up
Tabs should line up
Ground cable
Drive ground terminal
Pass the ground cable through
the bottom cover of the drive.
Through-hole
for ground cable
Ground
cable