Emulex 355 - Manual (Page 21)

E MULEX M ODEL 355 SAN S TORAGE S WITCH
U SER ’ S G UIDE C HAPTER 3: S WITCH M ANAGEMENT
E MULEX C ORPORATION 18
P ART N UMBER 00041411-002 R EV . B
M
ANAGING THE
S
WITCH
The Emulex® Model 355 SAN Storage Switch provides several options for managing and configuring
the switch to meet the needs of the network environment.
This section describes how to log in to the switch, configure switch and port settings, manage firmware
and configuration files, and configure One-Step Zoning, Automatic Trunking, and Load Balancing.
Frequent Switch Configuration Tasks
A list of frequent switch configuration-related tasks is provided below. The list displays the task, the
corresponding Web Manager command, and a reference to where more information may be found in this
guide.
For information on viewing switch status and information, see “Monitoring the Switch” on page 46 .
To… Click… In this guide, see...
View switch status Storage Switch “Viewing Switch Status” on page 46 .
Change general switch
configuration Switch > Configuration “Configuring the Switch Settings” on
page 19
.
Change the IP Address Switch > Configuration “Network Location” on page 20
Change the switch speed Switch > Configuration “Switch Speed” on page 21 .
View the event log Switch > Event Log “Viewing the Event Log” on page 48 .
Configure traps Switch > SNMP Traps “Setting SNMP Traps” on page 22 .
Upgrade the firmware Switch > Files “Switch Firmware Files” on page 34 .
Change the Port Smart
Settings Port > Smart Settings “Configuring the Port Smart Settings” on
page 26
.
Configure One-Step Zoning Advanced Functions >
One-Step Zoning “One-Step Zoning” on page 35 .
Configure Automatic
Trunking Advanced Functions >
Automatic Trunking “Automatic Trunking” on page 43 .
Configure Load Balancing Advanced Functions >
Load Balancing “Load Balancing” on page 44 .
Reset the switch Reboot “Configuring the Switch Settings” on
page 19
.