Epson DW621 - Manual (Page 10)

7
English
Your router is equipped with constant speed cutting—as you load the router, the selected cutting speed
does not slow down during normal use. The electronic control governs the motor and gives you a
consistent finish to your work. Only under very heavy loading will the speed of the unit fall below the
governed speed.
To set the router speed (from 8,000 rpm to 24,000 rpm) rotate the speed control wheel shown in
Fig. 3. The higher the number the higher the speed. Consult the table below to help select the proper
speed for your application.
Table A
SPEED SELECTION CHART
Material Cutter Diam. Electronic Control Settings
Setting 1 Setting 2 Setting 3 Setting 4 Setting 5 Setting 6
Model # DW621 8,000 rpm 12,000 rpm 14,000 rpm 18,000 rpm 21,000 rpm 24,000 rpm
Hardwood, e.g., oak Small (1/2") – – O X XX X
Medium (1/2"-1 1/8") – – O XX X -
Large (over-1 1/8") X XX O – – -
Softwood, e.g., pine Small (1/2") – – O X XX XX
Medium (1/2"-1 1/8") – O X XX XX XX
Large (over-1 1/8") X XX O – – -
Plastic-laminated chipboard Small (1/2") – – O X XX XX
Medium (1/2"-1 1/8") – O X XX XX XX
Large (over-1 1/8") O XX X – – -
Plastics/ Solid Surface Small (1/2") – O X X XX XX
Medium (1/2"-1 1/8") – O XX XX X X
Large (over-1 1/8") X XX O – – -
This table can serve only as a guide, since wood was a living material. Within the same species of timber hardness and density vary.
Speed settings are approximate.
KEY: XX very good X good O Satisfactory – not recommended