Extron Electronics DVI DL 101 - Manual (Page 9)

DVI DL 101 • Installation and Operation
Installation and Operation, cont’d
2-4 DVI DL 101 • Installation and Operation 2-5
(2) 4-40 x 3/16"
Screws
Use 2 mounting holes on
opposite corners.
VersaTools Rack Shelf
1/4 Rack Width Front
False Faceplate
Mounting the DVI DL 101 on a 3.5” deep rack shelf
Under-furniture mounting
The DVI DL can be mounted under a horizontal surface using an
optional MBU 125 under-desk mounting kit (part #70-077-01), as
follows:
1
. If rubber feet were previously attached to the bottom of the
unit, remove them.
2 . Remove the screws from one side of the unit. Retain the
screws for possible later reassembly.
3 . Attach one bracket to the side of the unit, using the
provided machine screws (see the illustration on the next
page).
4 . Repeat steps 2 and 3 on the other side of the DVI DL.
5 . Hold the unit with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the bracket’s screw holes.
Under-furniture mounting the DVI DL
6 . Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
7 . Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than 1/4" of the screw head protrudes.
8 . Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
9 . Slide the unit slightly forward or back, then tighten all four
screws to secure it in place.
Through-furniture mounting
The DVI DL can be mounted through a desk or other furniture
using an optional Extron MBD 129 through-desk mounting kit
(part #70-077-02) as follows:
1
. Loosely attach the mounting brackets to the unit using
the four machine screws and washers supplied with the
mounting kit.
2 . Hold the unit against the inside of the surface through
which it will be mounted. Mark the four screw holes on
the inside of the surface to which you are mounting the
device.
3 . Cut out the material from the installation area with a
jigsaw.