Extron Electronics DVI DL 101 - Manual (Page 10)

DVI DL 101 • Installation and Operation
Installation and Operation, cont’d
2-6 DVI DL 101 • Installation and Operation 2-7
Through-desk mounting the DVI DL
4 . Drill four pilot holes, each 3/32" in diameter by 1/4" deep,
where you made marks.
5 . Using the provided four wood screws, secure the brackets
to the mounting surface.
6 . Slide the DVI DL up and down in the mounting brackets
until the front panel is at the desired height. Tighten the
screws that secure the brackets in place.
If the screws are inaccessible to a screwdriver:
a
. Mark the location of the brackets relative to the screws.
b . Remove the unit from inside the furniture.
c . Tighten the screws.
d . Replace the unit inside the surface (step 4).
Projector mounting
The DVI DL can be mounted on a projector bracket using either
of the following optional Extron projector mounting kits:
• PMK 300 projector mounting kit (part #70-374-01)
• PMK 350 low profile projector mounting kit
(part #70-563-02 [black] or part #70-563-03 [white])
PMK 300 mounting
Mount the DVI DL to a PMK 300 bracket as follows:
1
. If necessary, remove the feet from the bottom of the unit.
2 . Mount the receiver to one of the bracket’s three mounting
plates using two of the supplied 4-40 x 3/16" screws in
opposite (diagonal) corners to secure the device to the
bracket. It can be vertically mounted facing either up or
down (see the illustration below).
N On the side mounting plates, the device is typically
mounted on the outside of the bracket.
On the front mounting plate, the device is typically
mounted on the inside of the bracket.
Extron
PMK 300
Multi-product Projector Mount Kit
U-Bolt
Front Mounting
Plate
Side Mounting
Plate
Extron
DVI DL 101
Equalizer
Power Supply
Bracket
Brace
PMK 300 projector mounting a receiver
3 . Strap the power supply to one of the brackets, using the
two included tie wraps.
N The PMK 300 has a hole in the bottom plate that allows
the projector pole to be inserted through the center of
the plate, rather than outside of the plate). To install the
PMK 300 in this configuration, slide the bracket up from
the bottom of the pole before the projector is installed on
the pole.