Electrolux E24CM76GSS - Manual (Page 17)

17
Installation
CONNeCTING THe PlUMBING (e24CM76GSS)
Insert the 3/4” gasket into the 3/4” fitting on the water supply hose. Make sure
it is properly seated.
Connect the 3/4” end of the hose to the water inlet on the back of the coffee
maker.
Insert the 1/4” gasket into the 1/4” fitting on the water supply hose. Make sure
it is properly seated.
Connect the other end (1/4”) of the hose to the water supply.
•
•
•
•
Water Supply
Hose
Gasket
Back of Coffee
Maker
Power Cord
Water Inlet
WARNING
To prevent damage to the coffee system due to hard water, prior to
installation, check the water hardness for the building where you will
be installing the coffee maker. See page 12
To avoid leaks, do not overtighten fittings.
•
•