Echo SHAFT HEDGE CLIPPER HCA-265 User Manual
Page 9
S
haft
h
edge
C
lipper
9
O
peratOr
’
S
M
anual
____ 1 - Power Head
____ 1 - Drive Shaft /Gear Case Assembly
____ 1 - Operators Manual
____ 1 - Hedge Clipper Safety Manual
____ 1 - Warranty Registration Card
____ 1 - Shoulder Harness
____ 1 - Blade Cover
____ 1 - 4 mm Hex Wrench
a
ssembly
Tools Required: 4 mm hex wrench, 8mm x 10mm Open End Wrench,
Screwdriver
Parts Required: Power Head, Drive Shaft/Gear Case Assembly,
Front (Loop) Handle Assembly:
Loop Handle, Handle Mounting Bracket
5 x 35 mm screws (2)
drIve
shaft
/
power
head
1. Stand power head upright on a level surface.
2. Loosen the two (2) drive shaft clamp bolts (B) at engine drive shaft
clamp, and remove center drive shaft location bolt (A).
3. Carefully fit driveshaft assembly to engine making sure that inner
drive shaft engages clutch mount.
4. Turn drive shaft housing until locating hole lines up with location
hole in clamp and install center drive shaft location bolt (A).
a
B
B
c
ontents
Due to packaging restrictions, some assembly is required.
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing
parts. Use the contents list to check for missing parts.