Polaris 2010 FST IQ Touring - Manual (Page 45)

42
FEATURES
Instrumentation
MFD Settings
The MFD control switch allows you
to set the MFD display to your pref-
erences. The rocker switch has a
MODE button (top) and a SET but-
ton (bottom). Specific instructions
are outlined on the following pages.
MFD settings can be made with the
engine running or with the engine
off. If the engine is off, make sure
the stop switch is pressed down, and
turn the ignition key to the START
position briefly to activate the
gauge. The gauge will illuminate for about 90 seconds.
Standard vs. Metric
The MFD will display either standard or metric units of measurement.
While viewing a screen that displays measurements (MPH, km/h or
temperatures), press and hold the MODE switch until the unit of mea-
surement changes (about 10 seconds).
MFD Control Switch
SET
MODE