Polaris 2008 Victory Vegas - Manual (Page 76)

71
OPERATION
Engine Break-in Period
Priming the Fuel System
Notice If the motorcycle has run completely out of fuel, prime the system before starting the engine: Turn the
ignition switch to the ON position. Toggle the engine stop/run switch from the STOP position to the RUN
position. Allow the fuel pump to run until it stops (about 3 seconds). Toggle the switch to the STOP posi-
tion and wait 3 seconds to allow the engine control module to reset. Repeat the RUN/STOP procedure
4-5 times, waiting 3 seconds between each toggle.
Starting the Engine
The VICTORY motorcycle has a starter interlock system. The engine can be started only when the transmission is
in neutral or when the transmission is in gear and the clutch is disengaged (clutch lever is pulled in).
Follow these steps to start the motorcycle:
1. Perform the Pre-Operation Check as outlined beginning on page 50. If you’re carrying cargo, inspect the cargo
restraints for tightness.
2. Insert the ignition key into the ignition switch and turn the switch to the ON position (see page 39).
3. Mount the motorcycle and bring it to an upright position. Engage the front brake and place the sidestand in the
stored (up) position. If the neutral indicator is not illuminated, shift the transmission to neutral (see Shifting
Gears, page 73).