Polaris 2003 Victory Vegas - Manual (Page 90)

88
MAINTENANCE
Drive Belt
Check Drive Belt Condition
Replace the drive belt if it is cracked or has broken teeth or frayed edges. No matter its condition, the drive belt
should be replaced at periodic intervals (see the Victory Service Manual or an authorized Victory dealer).
DO NOT
attempt to check belt tension if the belt has been exposed to rain or washing within a 24 hour period or if the belt is hot from
riding. Allow the belt to cool down to ambient temperature before measuring belt tension.
Check Drive Belt Tension
This procedure involves using the belt tension gauge, part no.
PV-43532, which is designed specifically for measuring drive belt
tension.
Before beginning this procedure:
S Make sure the drive belt is dry and at room temperature.
S Make sure the rear suspension is properly adjusted (see “Adjust
Rear Shock Absorber” page 94).
1. Place the transmission in Neutral and lift the rear wheel off the
ground with an appropriate motorcycle lift or a block of wood or
steel placed securely under the frame.
Care should be taken to be sure the motorcycle will not tip or fall while elevated. Severe personal
injury or death may occur if the motorcycle tips or falls.
WARNING
1. Belt Tension Gauge
2. Small O-Ring
3. Base
4. Plunger
1
2
3
4