Polaris 2005 ATV Scrambler 500 4X4 - Manual (Page 48)

45
OPERATION
Break-In Period
The break-in period for your new 4-cycle Polaris ATV is defined as the
first ten hours of operation, or the time it takes to use the first two full
tanks of gasoline. No single action on your part is as important as
following the procedures for a proper break-in. Careful treatment of a
new engine will result in more efficient performance and longer life for
the engine. Perform the following procedures carefully.
CAUTION
Excessive heat build-up during the first three hours of operation
will damage close-fitted engine parts. Do not operate at full
throttle or high speeds for extended periods during the first three
hours of use.
Use of any oils other than those recommended by Polaris may
cause serious engine damage. We recommend the use of
Polaris Premium 4 Synthetic Oil for your 4-cycle engine.
1. Fill the fuel tank with
gasoline (see page 40).
2. Check the oil level on
the dipstick (see page
72). Add the
recommended oil as needed to maintain the oil level in the normal
operating range (1).
3. Drive slowly at first. Select an open area that allows room to
familiarize yourself with vehicle operation and handling.
4. Vary throttle positions. Do not operate at sustained idle.
5. Perform regular checks on fluid levels, controls and areas outlined
on the daily pre-ride inspection checklist. See page 46.
6. Pull only light loads.
7. During the break-in period, change both the oil and the filter at 25
hours or one month, whichever comes first.
ADD 8 OZ. NORMAL FULL
1