Grass Valley TTN-BES-0808CP/110 - Manual (Page 18)

BES-0808CP/110 Rev. 2
10
5.4 Programming of restrictions
If the user enables the Restrictions option, the previously programmed restrictions will be fetched from
the on-board memory during power-up. New restrictions may be programmed by putting the panel in
“Programming mode”. This is done, starting from Panel Disable state, by pushing and holding “V/A
toggle”, “Take On/Off” and “Take” and then pushing “Panel Enable”. Blinking “Panel Enable” and
“Take” indicates programming mode.
All the legal inputs for the selected output are shown by orange light in button. Pushing the appropriate
input button does the Legal/Illegal toggle. When a new output is selected, the programming of the
previous output is saved in the on-board memory and the old setting of the new output is fetched from the
on-board memory.
Push Panel Disable to stop the programming mode when all necessary programming is finished.
Disabling all inputs for the given output disables an output completely. When in normal mode these
outputs may be selected for viewing the status, but not controlled.
6 Connecting AES/EBU signals to the BES-0808CP/110
Below you will find our standard pin-out for DB25 audio contacts. This pin-out is used for both analog
and digital audio routers. The same standard is used by Tascam and Fostex.
Channel 1
+ 24 - 12 Gnd 25
Channel 2 + 10 - 23 Gnd 11
Channel 3 + 21 - 9 Gnd 22
Channel 4 + 7 - 20 Gnd 8
Channel 5 + 18 - 6 Gnd 19
Channel 6 + 4 - 17 Gnd 5
Channel 7 + 15 - 3 Gnd 16
Channel 8 + 1 - 14 Gnd 2
All audio contacts used on the routers are female type.