Grass Valley TTN-BRS-0808 - Manual (Page 16)

BRS-0808 Rev. 2
8
5.3. Power up mode
Switch 8 on the configuration switch defines the power up mode. The BRS-0808 router provides two
modes for powering up the system.
Mode 1 makes hard reset.
Mode 2 switches all outputs according to the buffered information in the routers processor system.
The power up mode can be switched according to the following pattern:
- means switch down
* means switch up
Switch 8 Power Up Reset
- Mode 2
* Mode 1
Default is Mode 2.
6. Connecting RS-422 signals to the BRS-0808
All ports (sources and destinations) on the BRS-0808 are coupled in accordance to the SMPTE-207M
standard. All RS-422 connectors used on the router are female types DB9.
Sources (Controlling)
These are intended for direct (one-to-one) connections to Controlling equipment, and they are therefore
assigned according to SMPTE207M Tributary:
Pin
3: RX+
Pin 8: RX-
Pin 4,6: GND
Pin 2: TX-
Pin 7: TX+
Destinations (Controlled)
These are intended for direct (one-to-one) connections to Controlled equipment, and they are therefore
assigned according to SMPTE207M Bus Controller:
Pin
7: RX+
Pin 2: RX-
Pin 4,6: GND
Pin 8: TX-
Pin 3: TX+