Grass Valley T2 Classic iDDR Quick Start - Manual (Page 5)

T2 ― Quick Start Guide ― 5
Rear panel
AC Power inlet (3 pin)
Mouse port (PS/2)
Keyboard port (PS/2)
Serial port
Monitor port USB (2.0)
LAN
Sound
R1 input section P1 output section
P2 output section
REF IN
GPI I/O
IEEE1394
MONITOR
REMOTE RS422
Analog audio I/O section
Main power switch
AC Power inlet (3 pin) Use the supplied power cable and connect to the AC power.
Main power switch Turns the main power ON/OFF.
Analog audio I/O section Used for analog audio I/O.
Mouse port (PS/2) Used to connect a mouse.
Keyboard port (PS/2) Used to connect a keyboard.
Serial port Not used.
Monitor port Used to connect a PC monitor.
USB (2.0) Used to connect a keyboard or mouse.
LAN Used to connect a LAN cable.
Sound Not used.
R1 input section Used for inputting to the R1 channel.
P1 output section Used for outputting from the P1 channel.
P2 output section Used for outputting from the P2 channel.
REF IN Used to input REF signal.
GPI I/O Used for GPI I/O.
IEEE1394 Used to connect a device via IEEE1394.
MONITOR Used for audio monitor.
REMOTE RS422 Used for remote control of R1, P1, P2 channels.
NOTE
To set the AC power supply cable fastener, use the supplied screws to fix the
power cable and the AC power supply cable fastener to your T2.
Never loosen the screws that fasten the fan.