Exmark Metro 21 Series User Manual
Page 14
- 9 -
NOTE: You can adjust the handle height for comfortable operation. Stand behind
the handle to determine the height. To adjust the handle height, position the
carriage bolts into the upper, middle, or lower mounting holes in the handle latches
and secure with the black knobs.
3.
For units with Honda Engines: Slide the bag support rod through the bag alignment
plate and into the upper, middle, or lower mounting holes in the handle and secure
each end with a cap locknut (Fig. 1). The bag support rod mounting hole location
corresponds with the mounting hole location for the handle latches as shown in the
table below.
Bag Support Rod
Mounting Hole Location
Handle Latch
Mounting Hole Location
Lower Lower
Middle Middle
Upper Upper
Secure the top of the bag alignment plate with a carriage bolt and cap locknut (Fig. 1).
For units with Kawasaki Engines: Slide the bag support rod into the upper, middle,
or lower mounting holes in the handle and secure each end with a cap locknut (Fig.
1). The bag support rod mounting hole location corresponds with the mounting hole
location for the handle latches as shown in the table above.
4. Use a cable tie to secure the control cables to the left handle below the bag support
rod.
3.2 Installing the Starter Rope (Units without a Blade Brake Clutch Only)
1. Pull the starter rope from the engine through the rope guide on the handle (Fig 2.).
Figure 1
Figure 2
Rope Guide
Starter Rope