Exmark Metro 21 Series - Manual (Page 11)

- 6 -
1.5.5 Gasoline powered equipment or fuel containers should not be stored in a basement
or any enclosed area where open pilot lights or heat appliances are present.
1.5.6 Maximum mowing results and safety can only be achieved if the mower is
properly maintained and operated correctly.
1.5.7 Check all bolts frequently to maintain proper tightness.
1.5.8 Keep all guards, shields and safety devices in place and in safe working condition.
1.5.9 Frequently check for worn or damaged components that could create a hazard.
1.5.10 All replacement parts must be the same as or equivalent to the parts supplied as
original equipment.
1.6 SAFETY SIGNS
1.6.1 Keep all safety signs legible. Remove all grease, dirt and debris from safety
signs and instructional labels.
1.6.2 Safety signs must be replaced if they are missing or illegible.
1.6.3 When new components are installed, be sure that current safety signs are
affixed to the replaced components.
1.6.4 New safety signs may be obtained from your authorized Exmark equipment
dealer or distributor or from Exmark Mfg. Co. Inc.
1.6.5 Safety signs can be affixed by peeling off the backing to expose the adhesive
surface. Apply only to a clean, dry surface. Smooth to remove any air bubbles.
1.6.6 Familiarize yourself with the following safety signs and instruction labels. They
are critical to the safe operation of your Exmark commercial mower.
PART NO.: 104-1329
LOCATION: Center of
Handle Bar
PART NO.: 68-7410
LOCATION: Top Center of
Mower Deck
For Push Units
PART NO.: 52-2610
LOCATION: Top Center of
Mower Deck
For Self-Propelled Units
PART NO.: 52-2620
LOCATION: Top Center of
Mower Deck
PART NO.: 77-0500
LOCATION: On Discharge Plug
PART NO.: 98-8017
LOCATION: On Grass Bag PART NO.: 93-7398
LOCATION: On Discharge Tunnel