Grass Valley SSP-3801 Installation v.1.2 - Manual (Page 37)

33
SSP-3801
Installation and Configuration Guide
To configure the SSP-3801 card’s input/output settings:
1 Open and log into the SSP-3801 card’s web interface (see page 24 ).
2 From the menu, select Card Configuration > Input/Output.
Fig. 4-5: Input/Output page
3 In the Video Standard list, select the video standard that the card will output.
4 In the Monitor Output Source list, select the source to be sent to MON, which can be
used as a troubleshooting aid, for sending a clean feed, or previewing a source event
about to go to air when router control is enabled.
5 Optional: If you have cabled the card to a downstream broadcast monitor, you can
verify if the card is operating properly by selecting the Test Pattern Enabled checkbox.
Once you have saved the changes, a test pattern from the SSP-3801 card will playout to
the broadcast monitor. When you can confirm that the test pattern plays out, clear the
Test Pattern Enabled checkbox, and click Save again.
6 If you selected an SD standard, you can choose whether line 23 in PAL (625 Line) or lines
20 and 21 in NTSC (525 Line) contain video or carry closed captioning or widescreen
signaling (WSS). To carry closed captioning or widescreen signaling, select the Pass
Closed Captions/WSS checkbox.
7 In the AES Input Source list, select which type of AES cable is connected to the card.
8 Click Save to apply the changes.
Creating a restore point for Card Hot Swap
When an SSP-3801 card is configured and a restore point is created, the card’s system
identity is stored in the Densité frame’s memory. If changes are made to the System Identity
settings, you must create a new restore point otherwise old settings will be applied to the
card during a system restart or upon insertion of a new card such as when you switch a card
in a Densité frame without powering-down the system, which is known as a Card Hot Swap.
To create a restore point:
1 Open and log into the SSP-3801 card’s web interface (see page 24 ).
2 From the menu, select Card Configuration > Card Hot Swap.