Grass Valley PDR 200 Fibre Channel - Manual (Page 28)

Fibre Channel Installation
16 PDR 200 Fibre Channel Installation Manual
Board Retainer Brackets Removal
There are two retainer brackets located in the board area that must be removed
in order to install circuit boards. One is slotted so that it holds full-size boards
in place and helps maintain their alignment. Although the other bracket holds
short boards in place, it must also be removed to install any full-size boards.
This bracket has extenders which may be moved to adapt to the locations of any
short boards. See Figure 9 for locations and removals of the two board retainer
brackets.
To remove the board hold-down brackets, refer to Figure 9 and:
1. Use the Torx tool with the T10 bit to remove retaining screw ➊ for the top
slotted bracket from the side of the Profile chassis.
2. Lift bracket ➋ up and out of the chassis.
3. Use the Torx tool with the T10 bit to remove retaining screw ➌ from the
middle of the short board bracket.
4. Lift bracket ➍ up and out of the chassis.