Grass Valley 1200 Installation Planning Guide - Manual

Model 1200
Digital Production Switcher
Installation Planning Guide
NORTH AMERICA Grass Valley, CA (916) 478-3000 SOUTH AMERICA Miami, FL (305) 477-5488 EUROPE Marlo, UK (01628) 403699 ASIA Hong Kong (852) 5987118 JAPAN Tokoyo, (03) 5992-0621
©1994 The Grass Valley Group, Inc. A Tektronix Company. Grass Valley is a registered trademark of Grass Valley Group, Inc
The information in this publication is furnished for informational use only, is subject to change without notice, and should not be
construed as a commitment by The Grass Valley Group, Inc. The Grass Valley Group, Inc. assumes no responsibility or liability
for any errors or inaccuracies that may appear in this publication.
1
0
064911 Control Processor Module
064905 Crosspoint Module
064907 Keyer Module
064910 Program Mixer Module
064910 Preview Mixer Option Module
Power Supply
064914 SPG Submodule
064925 Chroma Keyer Submodule
064908 Key 1 Processor 064908 Key 2 Processor 064908 DSK Processor
064909 Borderline 064909 Borderline 064909 Borderline
064815/912 DAC Option
Control Panel
Signal Processor Frame
Frame Module and Submodule Locations
064913 Depth Option
064913 Depth Option
064815/912 DAC Option
Model 1 200
D I G I T A L
Satellite Auxiliary Control Panel Option
The Satellite Auxiliary Bus Panel provides remote control of the switcher’s auxiliary buses. It connects to
the switcher electronics frame via a serial control cable connected to a frame serial port. Power is supplied
by an external transformer which can be switched between 120 and 230 volts ac.
Power Supply Transformer
120 or 230 Vac selectable,
50–60 Hz, 10 Watts
DC connector
1.72"
(4.4CM)
19.00"
(48.3CM)
17.00"
(43.2CM)
7.50"
(19.0CM)
J2-Serial Control
Port (male 9-pin D) J1-DC Power input
12–22 Vdc
Removable Rack Ears
May be repositioned or removed
for flush mounting in a console
AC Connector
1 GND 2 RX - 3 TX + 4 GND 5 GND
6 GND 7 RX + 8 TX - 9 GND
Port fixed at RS-422,
9600 baud, 8 bits,
1 stop bit, no parity.
8327C03B (TP0717-00B)