Grass Valley 4000 Remote Aux Panel - Manual (Page 8)

2 Model 4000 Remote Aux Panel Upgrade Instruction Manual
Upgrade Instructions
Upgrade Instructions
Upgrade Kit
The Upgrade Kit contains the items listed in Table 1 . A 3/16 inch and 5/16
inch nutdriver and a #10 Torx screwdriver are required for completing the
upgrade.
Upgrade Procedure
1. Disconnect the DC power, communications, and Joystick Override
cables from the rear of the Model 4000 Remote Aux panel (
Figure 1 ) and
place the panel face down.
Note Cable locations are the same on the 1 RU, 2 RU, and 3 RU panels. Screw loca-
tions differ on the panels, but the process for removing and replacing them
is identical.
Figure 1. Model 4000 Remote Aux Panel (1 RU), Rear View
2. Using a 5/16 inch nutdriver, remove the nuts and screws holding the
back plate onto the panel.
3. Using a #10 Torx screwdriver, remove the center screw on the back
plate.
4. Using a 3/16 inch nutdriver, remove the jack screws on either side of
the Joystick Override connector and remove the back plate.
5. Locate the Model 4000 CPU Aux Control EPROM (position U2) on the
Model 4000 CPU Aux Control Board ( Figure 2 ).
Table 1. Parts List for the Upgrade Kit
Part Number Description Quantity
163-8220-01 CPU Aux Control EPROM 1
TB4058-00 Extractor tool 1
335-0385-00 Label for front of the panel 1
071-8079-00 Upgrade Instructions 1
DC POWER
COMMUNICATIONS
BUS
+
–
SHIELD
JOYSTICK
OVERRIDE
071_8079_02_r0