Grass Valley K2 Media Client Field Kit Upgrade Instruction Manual Nov.18 2008 - Manual (Page 8)

8 K2 Media Client Field Kit Upgrade Instructions July 22, 2008
K2 Media Client Field Kit Upgrade Instructions
10. Replace the codec board. Make sure screws are installed in the proper sequence, as
illustrated:
11. Replace the top cover.
12. Connect power cables.
13. Start up the K2 Media Client.
14. Log in to Windows.
15. When the AppCenter logon box appears, click Cancel and Abort .
16. Delete all configuration XML files in the C:\profile\config directory. These
configuration files cannot be saved and reused.
17. Delete the channel suites file in the C:\profile\ChannelSuites directory. The file
name begins with the K2 Media Client’s name. For example, if the name is
k2client1, then the file name is K2CLIENT1_localConnection.xml.
On restart, the K2 Media Client rescans hardware, discovers the new mezzanine
board, reconfigures appropriately, and writes a new configuration file.
18. Restart the K2 Media Client, log in to Windows and AppCenter, and open
Configuration Manager. The new channel should be available for configuration,
according to the decoder (play channel) or encoder (record channel) installed.
In addition, all settings on all channels are at the default values.
19. Configure all channels, making new settings on the new channel and returning
Loosely install
center screw 3
Install side
screws tightly 4
Tighten
center
screw 5
Install side
screws
6
Install side
screws 6
Connect large
power cable
On HD/SD models,
also connect
small power cable
7
Carefully engage the
RTP board 2
Move board into position,
then reach under and
connect XLR board cable 1